What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
13.06.2025 02:31

There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
This is 'the assistant's answer'
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
I post the exact comment here.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
Do married men know when their wives are having affairs?
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
This is the picture of an electronic coil of wire wound around a core of magnetic material.
One is “what exactly is in a ‘surge protector’ ? ”
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
The bolt then partially travels down the line to your home.
In what ways is Bollywood becoming westernized?
He then describes the function of a fuse.
He then asserts :
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
Why do many women like tall men?
There are two important concepts here.
At least they know the answer if they wanted it.
so, what happens?
How old is planet Earth? Is it 4.5 billion years old or 6,000 years old?
One
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
This device then solves the entire problem.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
But… the neutral is now “floating” because of the 1 ohm resistance.
Upvotes:
but I think this circuit , shows a few more pieces.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
The other is “what does a “fuse” do?”
What would have happened if Shin was a good movie instead of a bad one?
Because the load is inductive, the current lags the voltage.(by a bit).
First Sentence:
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
The MOV will conduct when the voltage exceeds 50% of line voltage.
what exactly is a ‘surge’ protector?
These devices are installed between the “hot” and “neutral” and protective ground.
Why didn't my ex fight for our relationship? He gave up so easily.
So, the voltage could go up to 500 volts, and the fuse will not open up.
2024–10–10[John johnson John Johnson ]
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
a photo is worth a thousand words.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
It also is a device that limits the change in current flow.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
but this device (an Inductor) … impedes the rapid changes in the current.
There are three different concepts here that are getting confused.
He then describes Rainy Season and Lightning.
What is lightning?
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
Barnstars:
This one hit behind the barn.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
(Dc diagram shown, AC is similar).
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
A fuse is a non-resetable over current circuit protector.
Now when you have a certain ac resistance, then a current flows in a loop.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
A circuit breaker is similar, but is resettable.
Edit 2024–10.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
The third is lightning and “how it gets conducted into a home.”
eight
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
For this case there are devices called Metal oxide varistors (MOV).
the problem then depends on "how fast does the fuse operate?".
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
At one ohm, the resistor has a maximum of 1 watt power.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
In schematic diagrams this is the symbol for a fuse:
nine
2024–10–16 [ OO OLAOYE OYEBODE ]
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
[image of Common-mode choke]
2024–10–14 [Omar Gharbi Omar Gharbi ]
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
These are simplified answers to the original question, and does not change anything I wrote above.
But it can get overloaded, and no longer works.
This is where the MOV conducts again, and dissipated the energy.
[old diagram got deleted by accident]
What does a fuse do?
It seems Mohan does not understand the difference between a comment and an Answer.
Here is a simplified AC power diagram.
An AC voltage/ current source, and an ac inductive load.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
This is where this question deviates from being a 'generic' question, and becomes more specific.